❄ Winter special: 40% off spring & summer bookings — code KP40-WINTER27
Kanan Painting · Ontario & QuebecCall (437) 238-9585

How Often Should You Repaint? Interior & Exterior Cycles

Paint is not permanent — it is a protective coating with a working life, and every surface in your house spends that life at a different rate. A bathroom wall and a bedroom wall painted on the same day will not be ready again on the same day. This guide gives the typical repaint cycle for each exterior surface and each room, the factors that shorten or stretch it, and the signs that mean "now" regardless of what the calendar says.

Interior painting from $2.49/sq ft

Call (437) 238-9585 Get a free estimate
Living room painted in warm grey by Kanan Painting — finished interior painting project
A recent Kanan Painting project

The short answer

As a planning rule: repaint the exterior every 7–10 years on most siding, longer on stucco and fibre cement; repaint high-use interior rooms every 3–5 years and quieter rooms every 5–7; expect a cabinet finish to work for 5–10 years. Those are typical ranges for a properly prepared job with quality paint — preparation and exposure move any individual house years in either direction, and visible failure signs always override the calendar.

One clarification, because the two are often confused: our own work carries a written 15-year workmanship warranty. That warranty covers how the work was done — it is not a claim that any paint film lasts 15 years. The cycles in this guide are about when a coating system typically needs renewal so the surface underneath stays protected. When your repaint is due, our interior cost guide and exterior cost guide break down what it runs, and the written estimate is always free.

Exterior repaint cycles, by surface

Outside, the surface itself sets the pace. Materials that expand, contract and absorb moisture spend their coating faster than materials that sit still:

SurfaceTypical cycleWhat decides it
Wood siding7–10 yearsThe most movement of any siding — boards swell, shrink and check. Full preparation and 100% acrylic paint reach the top of the range; thin prep or a hard-exposed wall can bring it down toward 5.
Vinyl & aluminum siding7–10 yearsThe panels barely move, so the film ages by UV and chalking rather than cracking. Fading, not peeling, is usually what ends the cycle — deep colours first.
Stucco8–12 yearsHigh-build acrylic and elastomeric coatings bridge hairline cracks and stretch with the wall. Recoat when cracks reappear through the film or the colour goes chalky.
Fibre cement10–15 yearsThe most dimensionally stable surface on the house, so a quality acrylic system lasts longest here. Caulked joints usually need attention before the paint does.
Painted brick5–10 yearsA film over masonry lives or dies on moisture management. Breathable masonry coatings and sound mortar reach the top of the range; trapped moisture shortens it sharply.
Brick stain10–20 yearsStain soaks into the brick instead of filming over it, so there is nothing to peel. It fades gradually and evenly rather than failing.
Decks & fences (stain)2–3 yearsHorizontal surfaces take foot traffic, standing water and full sun. Treat stain here as scheduled maintenance, not a failure — see our exterior painting service for what is included.

Why some of these jobs fail years early — and how the product choice changes the cycle — is covered in our guide to the best exterior paint for Canadian weather.

Stone-and-brick luxury home after exterior painting by Kanan Painting
A recent Kanan Painting project

Interior repaint cycles, by room

Inside, weather is not the enemy — contact is. Rooms cycle at the speed of their traffic, moisture and scrubbing:

RoomTypical cycleWhy
Kitchens3–4 yearsCooking grease settles on walls and ceilings, steam works on the film, and the walls get wiped and scrubbed more than anywhere else. The finish near the stove and sink goes first.
Bathrooms3–4 yearsDaily humidity cycles are the stress. Moisture-resistant paint in a satin or semi-gloss sheen reaches the top of the range; flat paint in a steamy bathroom is ready sooner.
Hallways, stairs & entries3–5 yearsThe highest-contact surfaces in the house: hands, bags, furniture and pets all pass within inches. Scuffs and shiny wear paths, not fading, end the cycle.
Kids' bedrooms & playrooms3–5 yearsMarks, stickers, tape and enthusiastic cleaning. A scrubbable paint in an eggshell or satin sheen stretches the interval.
Living & family rooms5–7 yearsModerate traffic and no moisture load. These rooms are usually repainted for a colour change before the coating itself has failed.
Adult bedrooms5–7 yearsThe lowest-wear rooms in the house — a gentle-use bedroom can go longer than the range and still look clean.
Ceilings7–10 yearsNothing touches them, so ceilings outlast walls — except over kitchens and showers, where steam and cooking film shorten the cycle. They are most often redone alongside the walls.

Room-by-room work like this is our interior painting service — one estimate can cover the rooms that are due now and leave the rest on the plan.

Cabinets, doors and trim

Kitchen cabinets — 5–10 years. A professionally sprayed finish stands up to daily use for years. Wear appears first where hands and water reach every day — around handles, the sink cabinet, the stove side. When the boxes are still sound, doors and drawer fronts can be refinished again rather than replaced; our cabinet painting service covers the process.
Interior doors & trim — 5–10 years. Trim takes the knocks — vacuum cleaners, shoes, moving furniture — and is usually repainted for scuffs, not film failure. Semi-gloss is the standard finish here because it is the hardest and most washable sheen in the house.
Window sills & frames — check yearly. Condensation collects on sills all winter, so the paint there works harder than any other interior trim. Catching a failed sill early is a touch-up; missing it for seasons becomes wood repair.

Signs it is time now — whatever the calendar says

The ranges above are for planning. These signs are not: any one of them means the coating has stopped doing its job, and waiting only makes the next job bigger.

Peeling, cracking or bubbling. The film has lost adhesion and moisture is getting behind it. Outside, exposed wood and masonry start taking damage; this is the one sign that should never wait for the "right" year.
Fading and chalking. Colour that has gone flat and a powdery residue on your hand when you rub the wall mean the resin holding the paint together is breaking down under UV. The coating is at the end of its protective life even if it has not peeled yet.
Failed caulk and open joints. Cracked or missing caulk at joints, windows and trim lets water behind the coating and into the wall. Joints often need attention a full cycle before the paint does — and re-caulking is part of preparation on any repaint.
Stains, mildew and water marks. Bathroom ceilings, walls under windows, and kitchen ceilings tell the truth about moisture. Stains that bleed back through a fresh coat mean the source needs fixing and a stain-blocking primer, not just more paint.
Scuffs and shiny wear paths. Indoors, the signal is cosmetic but real: hallways and stairwells worn shiny where hands and bags pass, trim nicked down to bare wood. The room looks tired long before the paint has technically failed.
You are selling or re-letting. Fresh paint is the highest-return preparation for a sale or a tenant change — it resets every cycle above at once and photographs like it. Turnover repaints are usually one neutral colour throughout, walls and trim together.

What shortens a paint job's life — and what stretches it

The same paint, on the same house, can last four years or ten. The difference is almost never luck:

Shortens it: skipped preparation. Paint applied over chalk, gloss, grease or damp surfaces bonds to the contamination, not the wall. Most of the early failures we are called to fix trace back to this — the finish was fine, the foundation was not.
Shortens it: the wrong product. Vinyl-acrylic blends instead of 100% acrylic, flat paint in a steamy bathroom, a non-breathable film on brick — the wrong coating on the wrong surface spends its life in the wrong conditions. We use Sherwin-Williams® and Benjamin Moore® paints. The specific product still has to match the surface.
Shortens it: sun and dark colours. South- and west-facing walls take the strongest UV, and deep colours absorb the most heat and fade fastest. These walls set the repaint date for the whole exterior.
Shortens it: painting outside the window. Cold surfaces, wet walls, an overnight frost during the cure — a job applied outside its temperature and moisture window can lose seasons of life before it starts. Our Canadian weather paint guide covers the window in detail.
Stretches it: full preparation. Washing, scraping, sanding, the right primer and fresh caulk are what the finish coat stands on. It is the least visible part of the job and the one that decides the cycle length.
Stretches it: small maintenance. Rinsing salt and mildew off lower walls each spring, touching up failed caulk and exposed end grain before water gets in, and wiping kitchen walls down before grease builds — minutes of work that add years.

Planning your repaint cycle

You do not have to repaint everything in one year. A simple rotation keeps every surface inside its cycle and spreads the cost:

  1. Walk the house once a year. Ten minutes each spring: check exterior caulk and the sunny walls, bathroom ceilings, hallway scuffs and cabinet doors around the handles. Note what is aging — the list writes next year's plan.
  2. Stagger the big surfaces. Exterior one year, main-floor interior another, bedrooms and cabinets on their own years. Nothing falls due at once, and no single year carries the whole house.
  3. Bundle what shares the work. Rooms being repainted in the same colour family, and ceilings with their walls, cost less done together than as separate visits — the preparation and setup happen once.
  4. Book exterior work for the window. Ontario's exterior season runs late spring through early fall. Booking ahead puts your project in the good weather instead of at the end of the queue.
  5. Keep a one-line record. Date, surface, product and colour for each job. It makes the next estimate faster, colour matching exact, and tells you at a glance which surfaces are coming due.

Winter reservations for April–October work are 40% off with code KP40-WINTER27 — booking in winter is how a due exterior gets first pick of the spring window.

Related guides and services

Repaint timing questions, answered

How often should you repaint the exterior of a house?

For most Ontario homes, every 7–10 years on wood, vinyl and aluminum siding with a properly prepared quality acrylic job. Stucco and fibre cement usually run longer — roughly 8–12 and 10–15 years — because the surfaces move less. Exposure matters more than the calendar: a shaded, well-prepared wall can outlast the range, and a hard-exposed south wall can need attention sooner. Peeling, cracking or failed caulk means now, whatever the date says.

How often should interior walls be repainted?

Living rooms and adult bedrooms typically go 5–7 years. Kitchens, bathrooms and hallways — the rooms with grease, moisture and constant contact — are usually ready in 3–5 years, and ceilings every 7–10. Scuffs, stains and sheen worn shiny in traffic paths are the real signals; a room that still looks clean and even can safely wait.

How long does painted cabinet finish last?

A professionally sprayed cabinet finish typically lasts 5–10 years in a working kitchen. Wear shows first where hands and water reach daily — around handles, the sink cabinet and the stove side. Doors and drawer fronts can often be refinished again when the boxes are still sound, which is why repainting cabinets starts from $1,399 instead of the several-times-higher cost of replacing them.

What happens if you wait too long to repaint?

The coating stops protecting the surface. Outside, failed paint lets moisture into wood and masonry, and the next job needs more scraping, repair and primer — sometimes board or stucco repair — before any paint goes on. Inside, the stakes are lower, but stained, shiny-worn walls in kitchens and bathrooms get harder to bring back with one repaint. Repainting on cycle is the cheaper cycle.

Do dark colours need repainting sooner?

On sun-exposed walls, usually yes. Deep colours absorb more heat and UV, so they fade and chalk faster — fastest on south- and west-facing exterior walls. Quality 100% acrylic paint with UV-resistant colour slows it down — one of the reasons we use Sherwin-Williams® and Benjamin Moore® paints — and on vinyl siding dark colours also need vinyl-safe technology. Indoors, dark colours mainly show scuffs sooner in hallways and stairwells.

How much does repainting cost?

Interior repainting is priced at $2.49 per square foot of painted area, and kitchen cabinet painting starts from $1,399. Exterior work is priced by surface — our exterior cost guide breaks it down by part of the house, and stucco and siding painting starts from $2,299. Your exact figure comes in a free written estimate, because condition and prep are what move the price.

Get your free repainting estimate

Not sure whether a room or a wall is due — or overdue? Tell us what you have and send the form your way: text message, WhatsApp or email. It lands directly with us at (437) 238-9585 — the written estimate is free, and we will tell you honestly if a surface can wait.

Free written estimate — no obligation.

Please add your name and phone number so we can reply to your estimate request.
Choose photos here and the send buttons deliver them to us with your request — no need to attach them again in the chat. Max 5 photos, 10 MB each.

Request your free painting quote

5.0★ on Google (64 reviews) · 15-year workmanship warranty · WSIB covered & insured · Since 2017 · 3,200+ projects

Call (437) 238-9585 WhatsApp us